SAFETY GUARDS transform the inexpensive open tube fixture into an attractive and safe unit. They should be installed on all open tube fixtures which are mounted over hazardous areas or at a height of 12 feet or less.
Industry has found that the hazard of falling lamps due to impact, vibration from roof fans, machinery, low flying aircraft, cranes, etc., not only endangers their personnel, but can cause extensive damage to their machinery and product. Supermarkets and other public occupancies are constantly facea with vandalism and claims for injury from falling lamps and broken glass.
SAFETY GUARDS are constructed of 14 gauge special temper steel wire rod, welded into a rectangular mesh configuration. Wire spacing is 2" x 21/2" and actual length of guard is 473/4" for four foot fixtures. (Eight foot units are supplied with 2 four foot guards.) The length of the guard assures clearance of end plates, as well as perfect alignment for continuous row fixture mounting. End plates, where required, are available at additional cost. Finished in brite zinc, Safety Guards hinge from either side and are attached to fixtures by means of special clips.
Heavy duty, 11 gauge wire SAFETY GUARDS are available upon special request.
SAFETY GUARDS are required by Electrical Codes, Safety
Codes, Health Codes, and Military Standards. The National Electrical Code requires SAFETY GUARDS for:
- Commercial Garages—Repair & Storage Article 511-6b
- Gasoline Dispensing and Service Stations Article 514-4
- Fixtures near combustible material Article 410-5
- Fixtures over combustible material Article 410.6
- Flammable Anesthetics Article 517-4b
- Aircraft Hangers Article 51 3-5a
- Bulk Storage Plants
- Finishing Processes Article.516-5b
Extras:
Once you are viewing a PDF page in your browser, you can save it to your computer, Print it out, or attached it to an Email.
 » Catalog / Data Page - View, Save, or Print (PDF)
For photometric information on this product please » Contact Crownlite
|
Please Note:
- Fixtures are U.L. listed and l.B.E.W. Union made.
- Many fixtures can be configured to meet Federal/State/Local/ and Utility Rebate Program Requirements.
- Units can be manufactured in a variety of materials like steel, aluminum, or extruded aluminum, and may include: customized reflectors/shielding, special mounting, ballasting, and lamping arrangements, self contained emergency lighting, motion sensors, and many other options and accessories. If this is not the exact item or configuration you need, Please
» Contact Crownlite.
- Information supplied may change without notice. Consult factory for verification, samples, and minimum quantities.
|
|
